The EVK comes in 15 different variants for stepper motor driver ICs – from standard, micro step, low voltage to high voltage. This comprehensive solution covers supply voltages from 8 to 42V, enables ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

Rather than having the host Pi communicate directly with the stepper drivers, the 3+Pi features an onboard STM32F302CBT6 that handles the actual motor control.

An Arduino Mega 2560 clone is used to control four TB6600 stepper motor drivers, with a common OLED display module installed where the original display went.

Two-chip designs combining a microcontroller or DSP with a highly integrated driver IC simplify the design of a stepper-motor controller, while also enabling sophisticated control ...

Even first-time users can get a stepper motor moving as commanded in 30 min or less. Commands can be issued from any serial terminal program or from the EZ Stepper Windows program, but the EZHR17EN ...

Toshiba has launched an 4 x 4mm QFN24 stepper motor driver that can run from 4.5 to 33V and deliver up to 1.2A. Typical on-resistance of the output block is 1.2Ω. “It is well suited for ...

The αSTEP AZ Series stepper motor driver offers superior high speed open loop performance with closed loop control. It incorporates a battery-free, absolute mechanical encoder for absolute-type ...

Toshiba Electronics Europe has extended its line-up of stepping motor driver ICs with a product that is capable of constant current motor control without the need for an external current sense ...

If you use the VCP (virtual COM Port) driver software provided with IC1 (available as a free down-load), the application program will view the USB stepper-motor controller module as another COM port.